If there’s one thing I’ve learned over the past five years, it’s that debate gives you new perspectives. Such was the case coming out of a webinar I presented in that was titled The Pros and Cons of 3D Modeling Paradigms: Direct Modeling and History-based Modeling. Brian Thompson of PTC and Dan Staples of Siemens PLM discussed which modeling approaches best fit the concept design and detailed design phases. The whole webinar is good, but the Q&A session at the end is where the real discussion began. That got me thinking about this topic.
If there’s one thing I’ve learned over the past five years, it’s that debate gives you new perspectives. Such was the case coming out of a webinar I presented in that was titled The Pros and Cons of 3D Modeling Paradigms: Direct Modeling and History-based Modeling. Brian Thompson of PTC and Dan Staples of Siemens PLM discussed which modeling approaches best fit the concept design and detailed design phases. The whole webinar is good, but the Q&A session at the end is where the real discussion began. That got me thinking about this topic.You can read the whole post, Direct Modeling is Better at Capturing Design Intent at the PTC Creo blog.